2500x1500 DIN 650 T Slotted Cast Iron Floor Plates

T Slotted Cast Iron Floor Plates Custom-Made

T- slots are machined according to DIN 650 , with popular metric or SAE sizes . T-slots can be machined to width tolerance H7 or H8 at extra cost. Depth of T- slots can also be increased in cases of extremely high pull- out loads. Casted pockets, as required, are provided along the T- slot enable inserting and removal of T- nuts. T- slots can be machined in longitudinal and transversal direction depending on your requirements as well as threaded holes and fitting holes.

Precision: According to the national standards measurement examination regulations execution,

respectively is 1,2,3, fine polish.

Installation and adjustment

When used surface plate ,you should first installation debugging,then you can use it . No significance work on surface plate if they aren't properly positioned .Surface plate should setup on level off, firm without shock place .please first put the pad iron down ,then put the surface plate on the pad iron ,removal the wooden case and oil . Measurement with the levelness of the surface plate ,when the surface plate isn't level ,please adjust the pad iron .( In the process of adjusting attention to safety)

Notice for use

1: To the best uniform use of the flat plate throughout, to avoid local grinding concave.
2: Keep the plate clean, prevent be wroned by iron scrap, sand ...
3: Put down workpieces on the plate gently, prevent the flat surface be impacted, once the plate surface hit the workpiece or other objects,repair impact and the convex part immediately.
4: Do not do any hammer work on the surface plate .
5: After use, should be clean it. If long time no use should not be coated with anti rust oil to prevent corrosion.